![]() I tryed to script it by using echo but than the setup gos in a loop. The problem i have with this is that i have to manually responed to some queastions. What i am doing now is the following: sudo apt install b. Windows Presentation Foundation Font Cache 3.0.0. Hello, I am trying to add a ubuntu pc to my groups. Logical Disk Manager Administrative Service ServiceName which should be used with ânetâ and âsc configâ commands. The first column shows the display name of a service and the second column shows the service name that should be used in net start or net stop or sc config commands. These service names are listed below for each service. So to start Remote procedure call service the command is: net start RpcSsTo stop Remote procedure call service net stop RpcSs ![]() But the service name we need to use in the above commands is RpcSs. For example, Remote procedure call (RPC) is the display name of the service. Replace with your actual password.Next, open your terminal, and run the below command to set a strong password for TeamViewer. SSH into your Raspberry Pi again if you are not already logged in. Each service is given a unique identification name which can be used with net or sc commands. Hi DavidEklove, Welcome to the TeamViewer Community. TeamViewerâs command-line interface (CLI) version allows you to configure and control the software from a terminal. Note that the service name is not the display name of a service. Again, if you do not have administrator previliges you would get the below error. This SC command works on a Windows 7 machine and also on the down-level editions of Windows i.e Windows XP/2003 and Windows Vista. Or enter the TeamViewer ID from the Raspberry Pi in the Partner ID field and press enter. Then, start the app via the Start menu or by typing TeamViewer in a terminal. Note: Space is mandatory after â=â in the above sc commands. If needed, you can also do it in the command line. To make a service start automatically with system boot: sc config servicename start= auto To enable a service: sc config servicename start= demand To disable a service: sc config servicename start= disabled If you are just a normal user on the computer, you would get an error like below. ![]() You need to have administrator privileges to run net start/stop commands. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |